In November 2026, Technical Appliance Service LLC repaired a Wolf stove in Riverhead, NY. The homeowner reported that the stove was not igniting. Our technician replaced the stove’s spark module.
The Problem: Wolf Stove Not Igniting
A stove that will not ignite cannot be used for cooking, even when the gas supply and the burners themselves look normal. On stoves with electronic ignition, the flame depends on a spark. If there is no spark, or the spark is too weak, the gas does not light.
A no-ignition problem can come from the spark module, the igniters at each burner, the burner switches, the wiring or the gas supply. Similar symptoms can lead to different repairs. On an LG gas stove in Huntington, both the igniter and the spark module were replaced.
What a Stove Spark Module Does
The spark module is a small electronic part that powers the ignition system. When a burner knob is turned to the light position, a switch signals the module, and the module sends high-voltage pulses to the igniters. Each pulse jumps from the igniter to the burner as a spark, which lights the gas.
On many stoves, one spark module serves every burner. That is why all of the igniters often click together when any one burner is turned on. When the module stops producing pulses, no burner gets a spark.
The Repair: Spark Module Replacement
Our technician replaced the spark module on this Riverhead Wolf stove. The spark module powers every igniter on the stove, so replacing it addresses the source of the ignition signal.
Signs a Stove Spark Module May Need Attention
These are general warning signs, not findings from this specific service call:
- No clicking from any burner when the knob is turned
- Weak or slow sparking, so burners take several tries to light
- Clicking that starts and stops on its own
- Several burners failing to light at the same time
If only one burner fails to light while the others work, the cause is more often that burner’s igniter, cap or switch than the spark module.
If you smell gas, do not try to light the burners. Turn the knobs off, leave the house and call your gas utility from outside.
Stove Repair in Riverhead, NY
Riverhead is among the Suffolk County communities served by Technical Appliance Service LLC. In nearby Calverton, also in the Town of Riverhead, we replaced the control board on a Maytag gas oven that was not heating. Our stove and range repair service covers burners that will not light, constant clicking, weak flames and unresponsive controls. See our Suffolk County appliance repair coverage for the other communities we serve.
If your stove will not ignite, call (929) 585-2342 or schedule a service visit. The diagnostic fee is $90 and is waived when the repair is completed.
Frequently Asked Questions
What was done to the Wolf stove in Riverhead?
The stove was not igniting. Our technician replaced the spark module.
Can a bad spark module stop a stove from igniting?
Yes. The spark module sends the high-voltage pulses that the igniters turn into sparks. If the module fails, the igniters get no power and the burners do not light. A worn igniter, a faulty burner switch or a wiring problem can cause the same symptom, so the cause has to be confirmed by an inspection.
Why do all my stove burners click when I turn on one?
On many stoves, one spark module powers every igniter at the same time. Turning any burner knob to the light position starts the module, so all igniters click together. Only the burner with its gas turned on lights.
Do you repair Wolf stoves in Riverhead, NY?
Yes. We repair residential Wolf stoves and ranges, as well as other major brands, in Riverhead and other selected Suffolk County communities. Call (929) 585-2342 to schedule service.